EUROM Heat-Duct-Pro 9 Manuel D'utilisation page 19

Technical data
Type
Supply voltage
Maximum capacity
Settings
Air flow
Protection class
Electrical cable
Plug
Dimensions
Weight
General safety instructions
1. Before using the machine, carefully read this entire
instruction manual. Keep this booklet in a safe place for
reference.
2. Before using your new heater, check it, including cord and
plug, for any visible damage. Do not use a damaged heater,
but send it back to your dealer for replacement.
3. This heater is exclusively intended to heat workspaces such
as workshops, garages and storage spaces. Use the
appliance for this purpose only.
4. Under the terms and conditions described in this leaflet, the
heater can be used in wet or damp indoor spaces such as
bathrooms and laundry rooms. Do not place the heater in
the vicinity of taps, bathtub, shower, pool, fountains or other
sources of moisture. Make sure it cannot fall into water and
prevent water from getting into the heater itself. If, at any
time, the heater does fall into water, unplug it immediately!
Do not use a heater that has a damp interior but have it
repaired. Never immerse the heater, cord or plug in water
and never touch it with wet hands.
5. The supply voltage and utility frequency, specified on the
machine, need to match those of the socket that is used.
The electrical installation needs to be protected by a
residual current device (max. 30 mAmp).
English
Heat-Duct-Pro 3
V / Hz 220-240 / 50
W 3000
W 0 - 3000
m³/h 389
IP24
H05RN-F 3G1.0mm²,
150cm.
Schuko
cm 36,5 x 26,5 x 37
kg 6
Heat-Duct-Pro 9
400 - 3~ / 50
9000
0 – 4500 - 9000
1227
IP24
H07RN-F 5G1,5mm²
150cm
5 pole – 16A
46 x 31,5 x 42
11,7
19