KOBE Brillia Serie Manuel D'installation Et Mode D'emploi page 10

Vent option installation
1. Choose the require vent option.
NOTE: If the hood is to be installed as ductless
application, please do not remove any duct
knockout located at the top or the back of the
hood:
2. For 7" Round vent installation only:
Using a flat-head screwdriver to remove the
-
7" duct knockout. (Refer to Figure 5)
Attached the 7" exhaust plate using 8 screws
-
(provided). Refer to Figure 6.
3. For 3-1/4" x 10" vent installation only:
Using a flat-head screwdriver to remove the
-
top OR the rear 3-1/4" x 10" duct knockout.
(Refer to Figure 7)
Attached the 3-1/4" x 10" exhaust plate using
-
6 screws (provided). Refer to Figure 8 for
Top Vent OR Figure 9 for Rear Vent.
4. For ductless installation only:
Remove the recirculating plate located at the
-
top of the hood, refer to Figure 10.
Reinstall the recirculating plate horizontally
-
as shown in Figure 11.
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
8