Hilti NURON SIW 10-22 Mode D'emploi Original page 15

9 Troubleshooting
If a problem occurs, always observe the status indicator of the battery. See the section headed Status
indicators of the Li­ion battery.
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem by
yourself, contact Hilti Service.
Trouble or fault
Product does not work.
Running speed suddenly
drops considerably.
The battery runs down more
quickly than usual.
The battery does not engage
with an audible click.
Product or battery gets very
hot.
LEDs of the battery show
nothing
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12 Further information
For more information on operation,
qr.hilti.com/manual?id=2356083
This link is also to be found at the end of the documentation, in the form of a QR code.
*2356083*
Possible cause
The battery is not fully inserted.
Battery is discharged.
Very low ambient temperature.
The retaining lugs on the battery
are dirty.
Electrical fault.
Battery defective.
technology,
2356083
Action to be taken
▶ Push the battery in until it
engages with an audible click.
▶ Change the battery and charge
the empty battery.
▶ Allow the battery to warm up
slowly to room temperature.
▶ Clean the retaining lugs and
engage the battery in the
working position.
▶ Switch the product off immedi-
ately, remove the battery, keep
it under observation, allow it
to cool down and contact Hilti
Service.
▶ Contact Hilti Service.
environment and recycling, follow this link:
English 11