Lincar Betty 531 Turbo Mode D'emploi page 45

- Empty the burner basket from the fuel and put it again in its
correct place.
- Push P4 and keep it pressed for few seconds until the
display reports the start of the lighting
.
NORMAL STARTING CYCLE
- Push P4 and keep it pressed for few seconds
The appliance begins an automatic cycle to effect the lighting, this cycle is composed by 3
phases, which are shown on the display :
1- START (duration approx. 2min.)
(spurk plug lighting element heating)
3-FLAME LIGHT
(Burner stabilisation)
The equipment will check continually the room temperature, in
case that the programming power will not be enough to
overcome the selected values, the equipment will reduce
automatically the power to minimum to avoid waste of
combustible. In case that the equipment will reduce
automatically the power (modulation) the display signal
"WORK MODULAT"
EQUIPMENT OFF
-Pushing for some seconds the P4
screw driver motor will be disconnected and the pellet stop to fall down. The two fan ( the one
of gas combustion and the one of convection) will keep on for some minutes as the gas
temperature will be low enough, then it will be off automatically.
IT IT IT IT- - - - GB GB- - - - FR FR mod. 531 Turbo -531N Turbo
GB GB FR FR
2-LOAD PELLET (max. duration 18/20 min)
(fuel loading)
When the starting cycle is finished the equipment
will function on programming power.
on control panel, the equipment turn off. The
45/88