Star Progetti STAR6 Instructions D'utilisation page 14

N.B. If the programming is unsuccessful, repeat the programming process.
CONTROLLER 3
Put the selector on the card of the first controller as per the drawing
press button P1 on the card
•
press the red ON button within 2 seconds
•
press the red OFF button within 2 seconds
•
N.B. If the programming is unsuccessful, repeat the programming process.
HOW TO USE THE REMOTE CONTROL
Once the remote control has been programmed, proceed as follows:
SINGLE REMOTE CONTROL for making adjustments in one zone: press the red ON button, then
adjust the power by pressing the buttons MIN (red LED) – MED (orange LED) – MAX (green LED).
When it is first turned on, the controller will go to minimum (red LED) by pressing the ON button.
Press the red OFF button to shut it off.
MULTICHANNEL REMOTE CONTROL up to 3 zones for multiple controllers: press the green ON
button relating to channel L1 or L2 or L3. To adjust the power, press the buttons MIN (red LED) –
MED (orange LED) – MAX (green LED).
When it is first turned on, the controller will go to minimum (red LED) by pressing the ON button.
Press the green OFF button relating to channel L1 or L2 or L3.
MAINTENANCE
The STAR6 controller does not require any maintenance. However, it does need to be cleaned on
occasion using a dry anti-static cloth. Caution: Make sure to disconnect STAR6 from the mains
before performing any cleaning tasks. Do not clean using sharp instruments.
TECHNICAL DATA
220-240V power supply
•
50/60 Hz Frequency
•
Maximum load 6000 Watt (resistive loads only)
•
Room temperature -20°/+30°
•
Protection rating IP56
•
Soft start
•
Dimensions mm 210 height x 180 x 57 thickness
•
UP TO 5 REMOTE CONTROLS CAN BE PROGRAMMED FOR EACH CONTROLLER
•
Radio features
433 MHz radio frequency
•
3 channels for max 5 regulators each
•
Remote control configuration: via radio with internal button
•
Heater adjustments: MIN – MED - MAX
•
13