Coffee Preparation; Automatic Switch-On - WMF STELIO Aroma Digital Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
Start-up
Prior to the first use and after the device has not be operated for an extended period
of time, carry out a boiling process with fresh water without coffee grounds. To do
so, fill the tank (4) to the 8-cup mark, as otherwise the jug (7) can overflow.
Setting the current time
After connecting the mains plug to a socket, Set and 12:00 appear in the display
(6). Set the current time by pressing the buttons h and min. Confirm the time
. The Set in the display (6) will blink until the time is
by pressing the button
confirmed.
Note: The time must be reset after a power failure or after the mains plug has been
unplugged.
You can also reset the time by pressing the h and min buttons at the same time, the
Set blinks in the display (6) and you can set the time by pressing the h and min
buttons. Confirm the time by pressing the
button.
Programming the switch-on time
The device's automatic switch-on starts the brewing process automatically at the
desired time. The switch-on time can be programmed up to 24 hours in advance. It is
displayed when you press the
button for about 3 seconds, the
appears in the
display (6) and flashes Set . Set the time you want it to switch on by pressing the
buttons h and min. Confirm the time by pressing the
button.
This activates the automatic switch-on time.
Note: Confirm the switch-on time within 5 seconds, or otherwise the settings will
not be saved.
Note: The switch-on time must be reset after a power failure or after the mains plug
has been unplugged.

Coffee preparation

Open the water tank (4). To do so, swing open the lid (3) upward. Only pour cold
water into the tank (4). The water level indicator (5) is for the amount of fresh water
that is needed to brew the desired number of cups per 125 ml of coffee.
Open the filter (2) by swinging open the filter lid (1) upward. Place the paper filter
of the 1 x 4 size into the filter (2), but fold the stamped edge before doing so. The
paper filter should not protrude over the edge of the filter, therefore you must push
it down slightly with your hand.
Fill with the required amount of ground coffee. Depending on your personal taste,
use approx. 5–7 g of medium-fine ground coffee per cup. If it is ground too finely,
the filter (2) may overflow.
Then close the filter lid (1). It will audibly click into place.

Automatic switch-on

If the preparation should start automatically at the programmed switch-on time,
press down on the
button for about 3 seconds,
appears in the display (6) and
flashes Set. You can check the programmed switch-on time and change it by press-
ing the h and min buttons. Confirm the time by pressing the
button.
You can deactivate the automatic switch-on at any time by pressing the
button.
12

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Stelio

Table des Matières