Husqvarna ST 224 Manuel D'utilisation page 14

5. If the product has power steering, hold the left
steering trigger (D) to turn left. Hold the right steering
trigger to turn right.
To stop the product
1. Move the ON/OFF switch to the OFF position (if
equipped).
2. Remove the ON/OFF key.
To use the throttle control
• Turn the throttle control (A) to change the amount of
fuel used. Always operate the engine at full throttle.
A
To use the fuel switch
• Turn the fuel switch to open or close the fuel valve.
Operate the product with the fuel switch in the OPEN
position.
OFF
14
D
FUE
LCO NTR OL
INSTR UCTIO NS
ON
To use the choke control
• Turn the choke (A) to open or close the choke valve.
Use the choke to start a cold engine.
A
To adjust the skid plates
No adjustment is required for normal installation.
1. When the lock nut (B) is loose or the skid plate (A) is
not high enough from the ground, unlock the lock nut
(B) with a 13 mm open-ended wrench, to move the
skid plate up or down.
2. On flat surfaces, like asphalt roads, raise the skid
plates (A) 5-6 mm (0.2-0.25 in) off the ground. On
uneven surfaces, like gravel roads, make the
clearance between the ground and the product
larger with the skid plates to get the scraper bar
above the top of the gravel. Make sure that the
gravel and stones do not enter into the product. It
can cause personal injuries if objects are ejected at
high speed.
3. Tighten the lock nut (B).
To prevent freeze-up after use
Note: Controls and moving parts can be blocked by ice.
Do not apply much force to the controls. If you cannot
operate a control or a part, start the engine and let it
operate for some minutes.
1. Start the engine and let it operate for some minutes.
Stop the engine and wait for all moving parts to stop.
A
B
673 - 003 - 08.01.2020