Sirius PLUG&PLAY SI-1KIT410 Mode D'emploi page 48

·When the photovoltaic array is exposed to light, it provides a DC
voltage to the inverter.
WARNING
·Ensure that all DC cables are correctly wired and that none of the
wires are pinched or damaged.
·The maximum open circuit voltage of the PV modules included in this kit are
designed to not exceed the specified maximum input DC voltage of the micro
inverter. Do NOT use other component than ones provided in this kit.
CAUTION
·If the DC cable is too short for installation, use a DC Extension Cable to
connect PV modules to the microinverter.
·Use MC4 compatible DC connectors in the inverter side of DC extension cable,
included in this kit.
·Contact aftersales service for the requirements of DC connectors in the
module side of DC extension cable in case of needed.