AEG FAVORIT 50EI Notice D'utilisation page 32

32
Manual adjustment
Electronic adjustment
1. Press the on/off button to activate
the appliance.
2. Make sure that the appliance is in
setting mode. Refer to 'SETTING
AND STARTING A PROGRAMME'.
3. Press and hold Delay and Start at
the same time until the indicators
(A), (B) and (C) flash.
4. Press Program.
FILLING THE SALT CONTAINER
Turn the water hardness dial to the po-
sition 1 or 2.
• The indicators (B) and (C) go off.
• The indicator (A) continues to
flash.
• The display shows the setting of
the water softener. Example:
= level 5.
5. Press Program again and again to
change the setting.
6. Deactivate the appliance to confirm.
CAUTION!
Only use dishwasher salt. Other
products can cause damage to
the appliance.
Water and salt can come out
from the salt container when
you fill it. Risk of corrosion. To
prevent it, after you fill the salt
container, start a programme.
1. Turn the cap counterclockwise and
open the salt container.
2. Put 1 litre of water in the salt con-
tainer (only for the first time).
3. Fill the salt container with dish-
washer salt.
4. Remove the salt around the open-
ing of the salt container.
5. Turn the cap clockwise to close the
salt container.