Publicité
Les langues disponibles
Les langues disponibles
Selecting operating modes
3
Cleaning
4
Emptying the fresh water tank
5
Emptying the wastewater container
6
Filling the fresh water tank(without detergent), rins-
7
ing the device
Cleaning the fluff filter, cleaning the fresh water filter
8
Allowing the device to dry
9
Description of the device
Illustration B
Upholstery nozzle
1
Holder for accessories
2
Mains cable
3
Hook for spray/suction hose or cable hook
4
Spray switch
5
Suction switch
6
Casing
7
Type plate
8
Steering roller
9
Spray hose connection
10
Floor nozzle for carpet cleaning (Adv only)
11
Carpet adapter
12
Floor nozzle latch
13
Suction hose connection
14
Cover
15
Fresh water tank
16
Device carrying handle including suction pipe holder
17
Nozzle mouthpiece (red)
18
Union nut
19
Suction pipe (Adv only)
20
Nozzle mouthpiece (green)
21
D-handle (Adv only)
22
Handle (Adv only)
23
Handle lever
24
Lever on the upholstery nozzle
25
Spray hose
26
Suction hose
27
Spray / suction hose
28
Quick Start Guide
29
Wastewater container, removable
30
Wastewater container carrying handle
31
Cover seal
32
Fluff filter
33
Fresh water filter
34
10
Table of nozzle mouthpieces
Colour Part
number
Yellow
6.415-
165.0
Green
6.415-
105.0
Brown
6.415-
166.0
Blue
6.415-
928.0
Red
6.415-
097.0
1. Check the power cord, extension cable and hoses
for damage before each start-up.
Installing accessories
1. Adv only: Fit the suction pipe onto the floor nozzle
and hand-tighten the union nut on the floor nozzle.
2. Adv only: If necessary, slide the D-handle onto the
suction pipe and hand-tighten in the desired posi-
tion. The D-handle is easier to slide on with the help
of dishwashing detergent or other lubricant.
3. Adv only: Fit the handle onto the suction pipe and
hand-tighten the union nut on the handle.
4. Connect the suction hose to the suction hose con-
nection on the device. Insert the spray hose cou-
pling into the spray hose connection on the device
and latch into place.
5. Connect the suction hose to the upholstery nozzle
or the handle. Connect the spray hose coupling to
the upholstery nozzle or handle and latch into place.
Mixing the cleaning solution
DANGER
Danger from detergents
Risk of injury and damage
Observe all instructions that are included with the deter-
gents used.
Note
Warm water (maximum 50 °C) increases the cleaning
effect. Check the temperature resistance of the surface
to be cleaned.
Note
Use detergents sparingly to conserve the environment.
1. Mix fresh water and detergent in a clean container
(concentration as specified for the detergent). Dis-
solve the detergent in the water.
Filling the fresh water tank
1. Pour the cleaning solution into the fresh water tank.
The filling level must not exceed the "MAX" mark.
Note
Foam is generated in the wastewater container when
cleaning previously shampooed carpets. Foaming can
be prevented by adding defoaming agents.
1. Add defoaming agent (special accessory) to the
wastewater container.
English
Flow vol-
Applica-
ume
tion
2.0 l/min
Floor noz-
zle
0.7 l/min
Floor noz-
zle
1.0 l/min
Floor noz-
zle
1.0 l/min
Uphol-
stery noz-
zle
0.55 l/min Uphol-
stery noz-
zle, short
Start-up
Defoaming agent
Approved
for device
Puzzi 10/2
Puzzi 9/1 Bp
Puzzi 10/1
Puzzi 8/1,
Puzzi 10/1,
Puzzi 10/2,
Puzzi 30/4
Puzzi 8/1,
Puzzi 9/1 Bp
Publicité
