Télécharger Imprimer la page

cecotec CONGA ROCKSTAR 3500 STORM FLEX ANIMAL Manuel D'instructions page 50

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 53
ENGLISH
Use a soft, slightly dampened cloth to clean the surface of the appliance. 
-
Never immerse the appliance in water or other liquids. Do not allow liquids to enter the
-
appliance. 
Do not use abrasive cleaners or scouring pads to clean the appliance. 
-
Do not leave the vacuum cleaner in a place with direct sunlight. 
-
-
Do not leave the vacuum cleaner in a wet place after cleaning it.
-
After the brush has been used for a long time, bristles might start to tangle with hair and
other particles. Clean it in order for it to operate correctly again.
Tank cleaning. Fig. 10
1.
Press the dirt container release button and remove the dirt container.
2. Empty the tank.
Cleaning the filters. Fig. 11
-
To prevent the appliance from overheating and losing suction power, it is suggested to
clean the filters frequently. To make the most of the suction power, it is suggested to clean
the filter after every use. 
-
The filters shelf life will depend on the accumulated use and the type of particles which are
frequently vacuumed. It is recommended to replace the filters every 6 months.
1. Press the dirt tank opening button and remove the dirt container.
2. Remove the filtering system from inside the dirt tank.
3. Separate the filters from the filtering system as shown in Figure 11. 
4. Vacuum and shake the filter to remove every particle and dust remain that may block them
and difficult the correct air circulation. Remember not to use the vacuum cleaner without
the filter properly assembled. Filters cannot be washed inside a washing machine nor
dried with a hair dryer. Do not brush the high-efficiency filter.
5. Put the filters back into the filtering system.
6. Put the filtering system back into the dirt tank.
7. Replace the dust tank on the appliance.
Cleaning the brush attachment
Slide the brush release button with your finger and remove the side cover.
-
-
Remove the brush.
-
It is important to remove any debris that may have been deposited in the brush inlet.
-
If you decide to wash the brush, you must air dry all the pieces. Assemble the pieces back
in order to use the brush again. 
How to remove the battery
Press the battery release button and remove the battery. Store the battery in a dry place.
50

Publicité

loading