MTD Yard Machines MCT333601 Manuel De L'utilisateur page 7

On some units, the handle may installed, but is turned
down under to help in packaging. In this case you must
adjust the handle to fit the operator.
INSTALL / ADJUST THE HANDLE
1. Place the handle on the drive shaft.
2. Insert the bolt through the handle in secure it with
the washer an wing nut (Fig. 1).
3. Adjust the handle to fit the operator and tighten the
wing nut.
Shaft
Washer
Wing Nut
INSTALL THE CUTTING ATTACHMENT SHIELD
NOTE: The cutting attachment shield must be installed
to properly dispense the trimming line.
To install the cutting attachment shield:
1. Place the cutting attachment shield onto the shaft
bracket (Fig. 2).
WARNING:
cutting attachment shield in place to pre-
vent serious personal injury.
ASSEMBLY INSTRUCTIONS
Handle
Bolt
Fig. 1
Never operate the
trimmer without the
Cutting Attachment
Shield
2. Insert the bolt through the shield, bracket, washer
and lock washer tighten with the wing nut (Fig. 3).
Bracket
Fig. 2
Wing Nut
Lock Washer
Washer
Bolt
Fig. 3
7