Safety Instructions; Scope Of Delivery; Product Description - Trotec VE 4 S MULTIQUBE Manuel D'utilisation

Table of Contents
Safety Instructions . . . . . . . . . . . . . B - 1
Scope of delivery . . . . . . . . . . . . . . B - 1
Product description . . . . . . . . . . . . . B - 1
Starting up . . . . . . . . . . . . . . . . . . . B - 2
Shutting down. . . . . . . . . . . . . . . . . B - 2
Cleaning and Maintenance . . . . . . . B - 2
Warning . . . . . . . . . . . . . . . . . . . . . B - 3
Fault Clearance . . . . . . . . . . . . . . . . B - 3
Technical Data . . . . . . . . . . . . . . . . B - 3
List of Spare Parts . . . . . . . . . . . . . . B - 3
Declaration of Conformity . . . . . . . . B - 4
This publication replaces all previous publications. No part of this publica-
tion may be reproduced, processed using electronic systems, replicated
or distributed in any form, without our written authorisation. Subject to
technical changes. All rights reserved. Names of goods are used without
guarantee of free usage and used for the most part according to the man-
ufacturers' syntax. The names of goods used are registered and should be
considered as such. We reserve the right to modify design in the interest
of ongoing product improvement, such as shape and colour modifications.
The scope of delivery may vary from that in the product description. All
due care has been taken in compiling this document. We accept no liability
for errors or omissions. © TROTEC
®

Safety Instructions

Please read these instructions carefully before
putting the unit into operation. The instructions
are to be kept either in close proximity to the
place where the unit is installed or near the actu-
al unit itself. This unit was subjected to compre-
hensive material, functional and quality checks.
Please remember, however, that there is still a
risk of danger if this unit is not used by trained
personnel or for purposes other than those stipu-
lated in these instructions.
Please note the following instructions:
• The VE units are to be employed as overpressure
and low pressure units; they are to be operated
in a vertical position only and placed on all 4
buffers or wheels on a level surface. The units
may not be used as a step or as a work surface
or place for depositing items.
• Do not operate the units when the relative humidity
is above 90% or in rain.
• During vacuum operation, particular attention
must be paid to ensure that no water or solid
substances enter the side channel compressor.
This can lead to a blockage of the turbines and
result in the destruction of the appliance. The
correct water pre-separator must therefore be
connected prior to the compressor at all times
during vacuum operation. Operation VE 4 S with
water seperator WA 4i MultiQube (see fig.1).
• In order to avoid harmful dust emissions microfil-
ters must be used in each vacuum operation. (Ex-
ample of a microfilter see Fig. 2.). These must be
installed professionally between the vacuum com-
pressor terminals of the water seperator and the
air transport tube for the side channel blower. The
micro filters shown in the example are consum-
B - 1
ables and at pollution, saturation or, at the latest
after each use be disposed of properly.
• When using the filters in the proper manner,
particular attention must be paid to the maximum
air flow rate of the individual micro filters. An
increased air flow rate could otherwise dam-
age the filter inserts, resulting in the release
of particulate matter into the ambient air. It is
therefore necessary to ensure that the correct
micro filters are always installed in accordance
with the compressor type and vacuum perfor-
mance. These must be checked for damage or
saturation at suitable intervals depending on
the toxic content and toxic hazard and re-
placed when necessary.
• For the ideal vacuum operation of the VE Com-
pressor the use of a 4 fold distributor is provid-
ed (see fig. 3)
• The compressors may not be used in rooms
where there is a danger of explosion.
• The compressors may only be used by skilled
and trained personnel who have been instructed
as to the use of the appliance and who have
been trained in the field of restorative drying.
The operating instructions can be consulted if
the situation demands.Trained personnel are
persons who have been instructed or, if necessary,
trained to carry out the task assigned to them
and who have been informed of the possible
dangers in case of misuse.
• Repair and maintenance work on electrical
parts may only be carried out by a skilled elec-
trician.
fig. 1
Operating manual drying unit VE 4 S
• On construction sites the compressor VE 4 S can
basically only be operated in accordeance with
DIN VDE 100 via an electrical supply 1/N/
PE~230 V / 16 A / 50 Hz with a corresponding
ground fault circuit interrupter GFCI (RCD 30 mA).
• The cold air intake and outlet grilles at the front and
back side must be kept free.
• With use of extension cords and cable reels the
cable must always be completely unrolled.

Scope of delivery

Standard scope of delivery:
• 1 x compressor
• 2 x reducing clip connection 50mm/38mm
• 1 x operating instructions
Optional accessories:
• four point distributor
• unidirectional restrictor valvel
• sound absorber
• Micro filter

Product description

• The side channel compressor VE 4 S is mobile,
sound absorbing, electrically powered side
channel compressors developed for opera-
tion in occupied rooms where noise emission
should be kept to a minimum due to the nature
of the situation.
• The turbines are suitable for damp coursing
with floating screed, flat roofing (warm roof
constructions), raised floors etc.
• The VE models can be used for both overpres-
sure and low pressure processes.
• When used in connection with the mobile de-
humidifiers, water separators, micro filters, HEPA
filters and the shock absorbers in the Trotec
programme, the user possess a perfectly tuned
system which offers a whole range of dehu-
mi-difying combinations.
• WARNING: The turbines are designed solely
for the transportation of clean air and clean gas-
es. If the transportation medium contains solid
particles or other forms of contamination, then
a filter must be installed on the suction side
(e.g. water separator, micro filter). Particular
attention must be paid to ensure that no impu-
rities are sucked into the compressor or enter
the compressor when it is at a standstill. This
would result in damage to the compressor,
which would in turn constitute a write off.
fig. 2
fig. 3
EN