Cleaning The Premotor Filter; Changing The Battery - Genius Invictus X7 Mode D'emploi

Cleaning the premotor filter

Cleaning/replacing the HEPA filter
NOTE!
Only use cold water to clean the filter and allow all parts to dry COMPLETELY before reassembling.

Changing the battery

Instructions for use
Pull the premotor filter up and out of the main unit. Both compo-
nents (the outer fabric ring and the inner foam rink) can be tapped
against a hard surface or held under running water to clean them.
To ensure full functionality, the HEPA filter should be cleaned
regularly and replaced every 4-6 months.
Remove the filter unit by pressing the locking mechanism together
with two fingers and pulling it out of the main unit.
To remove the HEPA filter, unscrew the screw on the inside of the
filter unit.
Clean the HEPA filter by tapping it on a hard surface. If it is very dirty,
wash it under running water.
Put the cleaned or new filter in the filter unit and replace the screw.
Switch the appliance off. Press the battery release button and hold it
down. Remove the battery.
Insert a new battery and make sure you hear it clicking into place. If
you cannot insert the battery completely into the main unit, check to
see whether you have positioned it correctly.
GB
35