Cleaning And User Maintenance - Genius Invictus X7 Mode D'emploi

Masquer les pouces Voir aussi pour Invictus X7:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

GB

8 Cleaning and user maintenance

WARNING!
Risk of electronic shock!
Always switch off and unplug the appliance before cleaning it or performing maintenance.
Never hold the main unit and battery under water or immerse the appliance in water or other
liquids.
NOTE!
Do not use soap or detergent to clean the premotor filter or HEPA filter because this will damage the
filter.
Allow the filter to dry naturally in the air. Do not use a hair dryer or other appliance to dry it.
Do not use any aggressive or abrasive cleaning agents to clean the housing. They could damage the
surface. Clean the housing with a damp, soft cloth when necessary.
Cleaning the dust container and cyclone filter
34
Instructions for use
The dust container can be detached from the main unit for thorough
cleaning.
First open the dust container and remove the cyclone filter by
twisting it in an anti-clockwise direction and pulling down. Close the
dust container and press the release button on the main unit's base.
Hold the button down, tip the dust container away from the main
unit and remove it with your other hand.
To insert the dust container back into the main unit connect it at the
top front side first (ensure that you have positioned it correctly).
Then press it into the main unit until you hear it click into place and
replace the cyclone filter. Observe the markings on the filter and
inside the dust container.
Clean the dust container with a brush or damp cloth.
There are power cables for the motorized power brushes inside the
dust container. Take care not to get them wet when you clean the
dust container.
The cyclone filter can be cleaned with a brush or under running
water, if necessary.

Publicité

Table des Matières
loading

Table des Matières