Ego Power+ CS2000 Guide D'utilisation page 49

TROUBLESHOOTING
PROBLEM
Motor does not
run.
Chain saw stops
running during
operation.
56V LITHIUM-ION CORDLESS 20" CHAIN SAW — CS2000/CS2000-FC
CAUSE
◾
The battery pack is not
attached to the chain
saw.
◾
No electrical contact
between the saw and
battery pack.
◾
The battery pack charge
is depleted.
◾
The battery pack or
chain saw is too hot.
◾
Chain brake is engaged.
◾
Saw chain is bound in
the wood.
◾
Debris in bar groove.
◾
Debris in side cover.
◾
The chain saw is
overloaded.
◾
The battery pack or
chain saw is too hot.
◾
Saw chain is bound in
the wood.
SOLUTION
◾
Attach the battery pack to the chain saw.
◾
Remove battery pack, check contacts and
reinstall the battery pack.
◾
Charge the battery pack.
◾
Allow the battery pack or chain saw to
cool until the temperature drops to the
recommended operating temperature
range.
◾
Pull the chain kickback brake paddle
backward toward the front handle (to the
operating position).
◾
Release the trigger switch; remove the
saw chain and guide bar from the wood,
then restart the chain saw.
◾
Press the saw chain against the wood,
move the chain saw back and forth to
discharge the debris.
◾
Remove battery pack, then remove side
cover and clean out debris.
◾
Decrease the load.
◾
Allow the battery pack or chain saw to
cool until the temperature drops to the
recommended operating temperature
range.
◾
Release the trigger switch; remove the
saw chain and guide bar from the wood,
then restart the chain saw.
49