Publicité
Les langues disponibles
Les langues disponibles
PLACEMENT OF THE MOUNTING PLATE
1
.
REMOVING THE MICROWAVE
A
OVEN FROM THE CARTON/
REMOVING THE MOUNTING
PLATE
1
Remove the installation instructions,use and care,
exhaust adapter, turntable ring, shelf, filters, glass
tray and the small hardware
the Styrofoam protecting the front of the oven.
please note: Do Not Remove plastic plug
protective cover until just before hanging the unit.
Small Hardware Bag
Filters and Turntable
Ring below glass tray
Fold back all 4 carton flaps fully against carton
2
sides. Then carefully roll the oven and carton over
onto the top side. The oven should be resting in
the Styrofoam.
Styrofoam
Pull the carton up and off the oven.
3
Installation Instructions
bag.
Do not remove
Exhaust Adapter
Glass Tray
Carton
4 Cut the middle of the outer protective plastic bag to
remove the
m
ounting late
Screws
Mounting Plate
Remove the screws from each end of the mounting
5
plate. This plate will be used as the rear wall template
and for mounting. Reinstall the screws into the holes
where they were removed.
.
B
FINDING THE WALL STUDS
Wall
Studs
Center
1
Find the studs, using one of the following
methods:
A. Stud finder – a magnetic device which
locates nails.
B. Use a hammer to tap lightly across the
mounting surface to find a solid sound.
This will indicate a stud location.
After locating the stud(s), find the center by
2
probing the wall with a small nail to find the edges
of the stud. Then place a mark halfway between
the edges. The center of any adjacent studs should
be 16 (40.6 cm) or 24 (61 cm) from this mark.
3
Draw a line down the center of the studs.
THE MICROWAVE MUST BE CONNECTED TO
AT LEAST ONE WALL STUD.
EN-6
p
Screws
Publicité
