Publicité
Les langues disponibles
Les langues disponibles
2. PREPARE INSTALLATION (
Parts sold separately:
- ABWPD Series Backsplash, 36'' , 42'' or 48'' width (optional)
- AEWPD Series Decorative Flue, to be installed over the hood (optional)
- AWWPD Series Wall Extension, 36'' , 42'' , 48 or 60'' width (optional)
- Transitions, duct, elbows, dampers, wall and roof caps.
Refer to pages 3 for a complete list of venting options and model numbers.
NOTE: During installation, protect countertop and/or cooktop.
3. INSTALL BACKSPLASH (
ABWPD Series (for 36'', 42'' and 48'' widths range hoods only)
Backsplash must be installed before the hood shell and wall extension (if needed) because the hood
shell (and wall extension) covers the backsplash top mounting screws (see instructions packed with
backsplash).
4. INSTALL WOOD MOUNTING STRIP
Due to the weight of this hood, ensure that the wood strip is attached to all of the
available studs and blocking; not into the wall alone.
1. Proper structural support is required to accommodate the weight of the hood. Construct the wall
framing using minimum 2" x 4" lumber.
2. Mark the center location of the hood.
3. Measure and mark a level line on wall above cooktop location for the wood mounting strip (see
illustration on page 4). Install 2" x 4" blockings between wall studs where mounting strip will be
installed. Refer to illustration below.
4. Remove wood mounting strip from back of hood.
5. Position the wood mounting strip on the wall and secure to the wall studs and blockings using
4 no. 10 x 2'' flat head screws (included in parts bag).
HD0482A
CONT
OPTIONAL
CAUTION
Existing
Wood Mounting
Wall Studs
'
)
D
)
Back of Hood
Strip
5
2" x 4"
Blocking
18"
16"
14¼" 15
"
1
⁄
8
Publicité
