Medisana HGN Mode D'emploi page 35

4.3
1.
Taking blood
2. If the START button
pressure readings
3. The unit is ready for measurement, the number 0 is displayed.
4. Following this the unit inflates the cuff until sufficient pressure has built up for a measurement.
5. When the measurement is finished, the cuff is deflated completely. The systolic and diastolic
6. The measured values are stored automatically. A total of up to 120 measured values with time
4.4
The unit has an automatic switch-off function. The unit switches off automatically after a minute if
Switching off
no buttons are pressed.
the unit The unit may also be switched off using the START button
The time and the date are constantly shown in the display.
Switch the unit on by pressing the START button
is pressed, a long beep is heard and all display characters are shown
(display test). Following this the memory currently set (U1 or U1) is displayed. Press the MEM
to change over to the other memory. Confirm your selection by pressing the START
button
button . The display shows the values from the previous measurement. If no measurement
has been taken, zeroes will appear next to the date and time.
Then the unit slowly releases air from the cuff and carries out the measurement.
blood pressure and the pulse value with the pulse symbol
blood pressure indicator
blood pressure classification (see page 24). If the unit has detected an irregular heartbeat, the
arrhythmia display also flashes.
and date can be stored in two memories (U1 and U2).
.
flashes next to the relevant coloured bar depending on the WHO
4 Operation
appear on the display
.
GB
. The
29