Venga VG RVC 3002 BK Mode D'emploi page 11

BEFORE FIRST USE
• Remove any power cords and small objects from the floor that may obstruct your
Venga! robot vacuum cleaner. Fold any tasselled edges of rugs underneath to
prevent tangling when vacuuming.
• Avoid cleaning very dark-coloured, high-pile rugs or rugs thicker than 1.02 in. / 26
mm, as they may cause the appliance to malfunction.
• Keep the robot vacuum cleaner away from spaces lower than 3.94 in. / 100 mm to
prevent it from getting stuck. If necessary, place a physical barrier to block off the
problem areas.
• Keep the robot vacuum cleaner away from wet areas.
• The robot vacuum cleaner may climb on top of objects less than 0.71 in. / 18 mm tall.
Remove these objects if possible.
• Place physical barriers in front of fireplaces and areas that could damage the robot
vacuum cleaner. It is also recommended to place physical barriers to block off areas
where the robot vacuum cleaner may fall.
• Remove the foam blocks beside the bumper before use.
NOTE: Cliff sensors prevent the robot vacuum cleaner from falling down stairs, steep steps
or slopes. The sensors can be impaired when dirty or when used on highly reflective / very
dark floors and work less effectively.
Cliff sensors can also be triggered by strong sunlight. If this causes the robot to move in an
unusual pattern, please use the curtains to prevent sunlight from entering the room, or
switch the robot on later when the strong sunlight has subsided.
A. Charging dock position
• Place the charging station against a wall
and on a flat surface. Avoid rugs or
carpets.
• Make sure the space is open and clear.
Pay attention to the following minimum
distances:
- 2 metres (6 feet) in front of the
charging dock
- 1 metre (3 feet) on both sides of the
charging dock.
VG RVC 3002 10