Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATION
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
Connect the connection cable-ends of the LED luminaries with the sockets of the controller.
Connect the controller to the mains with the power-plug.
With the POWER-switch, you can switch the device on and off.
You can select the programs by pressing the buttons on the controller.
Attention: The controller can be used with up to 12 luminaries.
The pin occupation of the connection-cables is as follows:
Pin:
Occupation:
1
+24V
2
Red
3
Green
4
Green
5
Blue
6
GND
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by authorized dealers only in
order to avoid hazards.
Should you have further questions, please contact your dealer.
DANGER OF FIRE!
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
12/23
00027034.DOC, Version 1.3
Publicité
Table des Matières
