Ryobi P460VN Manuel D'utilisation page 10

To operate the rotary tool:
 Secure all work in a vise or clamp to a workbench to
prevent it from moving under the tool.
 Hold the tool in front and away from you, keeping the tool
accessory clear of the workpiece.
 Turn on the tool and let the motor and accessory build
up to full speed.
 Lower the tool gradually until the accessory contacts the
workpiece.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
To avoid serious personal injury, always remove the bat-
tery pack from the product when cleaning or performing
any maintenance.
NOTE: ILLUSTRATIONS START ON PAGE 11 AFTER FRENCH
OPERATION
MAINTENANCE
AND SPANISH LANGUAGE SECTIONS.
10 — English
 Move the tool continuously at a steady, consistent pace.
 Use just enough pressure to keep the tool from chattering
or bouncing.
NOTE: Heavy pressure will decrease the tool's speed and
put a strain on the motor. The weight of the tool alone is
adequate for most jobs.
Lift the tool away from the workpiece before turning off

the tool.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.