Publicité
Les langues disponibles
Les langues disponibles
USE OF THE REMOTE CONTROL
Thanks to its Night & Day design, the projector can be turned on at night but also during the day; very useful function to
illuminate a dark room or a garage without window even in daylight.
NOTES:
1. The brightness level must be set before choosing the operating times (4h, 6h or 12h)
2. The motion detector option is not available when setting a specific light intensity (25%, 50%, 75% or 100%).
3. Both motion detection modes are factory set and cannot be changed. The light does will only light up with 100%
intensity or go from 30% to 100% output when motion is detected by the microwave sensor. Only the working time can
be adjusted.
4. The LED will blink twice when it receives the signal from the remote control successfully.
TIP:
In order to improve the battery life, the projector uses an intelligent consumption management program. 20 hours of
autonomy according to this program: 100% battery = 100% lighting power. As soon as the battery drops below 80%, the
light power also drops, of which 75% battery = 75% light power; 50% = 50% then 25% = 25% .... At any time, it is possible
to switch back to 100% light intensity by switching off and on the projector in manual ON / OFF Night & Day mode /
forced operation.
PRODUCT MAINTENANCE
CLEANING :
It is recommended that after use, the products be turned off, rinsed with clean water and dried with a soft cloth.
The battery is lithium battery LIFEPO4. The latter can be replaced by a Professional when the range of the LOOMI NEO
decreases despite a load of 08 hours in the sun.
When you're not using it : Keep these products out of reach of children.
13
Publicité
