mundoclima MUSTR-H11 Serie Manuel D'installation Et L'utilisauter page 59

Maintenance after a long stop period
(eg. at the beginning of the season)
Check and remove everything that might be blocking inlet and
outlet vents of indoor units and outdoor units.
Clean air filters and casings of indoor units.
Refer to "Cleaning the air filter" for details on how to proceed
and make sure to install cleaned air filters back in the same
position.
Check and remove everything that might be blocking inlet and
outlet vents of indoor units and outdoor units.
Clean air filters and casings of indoor units.
Refer to "Cleaning the air filter" for details on how to proceed
and make sure to install cleaned air filters back in the same
position.
Turn on the power at least 12 hours before operating the unit in
order to ensure smoother operation. As soon as he power is
turned on, the remote controller displays appear.
Maintenance before a long stop period
(eg. at the end of the season)
Let the indoor units run in fan only operation for about half a day
in order to dry the interior of the units.
Clean air filters and casings of indoor units. Refer to " Cleaning
the air filter" for details on how to proceed and make sure to
install cleaned air filters back in the same position.
Cleaning the air filter
The air filter can prevent the dust or other particulate from
going inside. In case of blockage of the filter, the working
efficiency of the air conditioner may greatly decrease .
Therefore, the filter must be cleaned once two weeks during
long time usage.
If the air conditioner is installed in a dust place, clean the air
filter frequent.
If the accumulated dust is too heavy to be cleaned, please
replace the filter with a new one(replaceable air filter is an
optional fitting).
1. Models 18 to 42
Open the air intake with the screwdriver or something like
that .(Refer to Fig.6-1)
Take out the air filter.(Refer to Fig.6-2)
Clean the air cleaning filter with water or vacuum cleaer,then
dry it in cool place.
Re-install the air filter in the reverse order of Fig.6-2.
2. Models 48 to 60
Directly pull out the air filter from air inlet as indicated in
Fig.6-3.
Clean the air cleaning filter with water or vacuum cleaner,
then dry it in cool place.
Re-install the air filter in the reverse order of Fig.6-3.
NOTE
The air-in side should face up when using vacuum cleaner.
The air-in side should face down when using water.
CAUTION
Do not dry out the air filter under direct sunshine or with fire.
59
Air Inlet
Fig.6-1
Air filter
Fig.6-2
Fig.6-3