PW1750
7.5
Rolling up the blind
➤ Loosen the fasteners of the roller blind.
➤ Pull the roller blind down (fig. h, page 8).
✓ The blind then rolls itself into the front panel.
➤ Pull the brackets on the right and left out of the rail (fig. i, page 9).
➤ Lock the lock in the middle of the front panel (fig. j, page 9).
A
NOTICE! Beware of damage.
If the roller blind is rolled up when wet, roll it out again at the next
opportunity and let the fabric dry out. If the wet fabric stays rolled up
for a long time, mildew will form and the fabric can fade.
7.6
Adjusting the 12 V motor (optional)
I
NOTE
The 12 V motor is pre-assembled in the roller tube.
➤ If the awning no longer fully closes or opens, then adjust the 12 V motor (fig. k,
page 9).
EN
Operating the awning
21