Dometic PERFECTWALL PW1750 Notice D'utilisation page 16

Operating the awning
7.2 Extending the awning
Extending the awning using a hand crank
!
WARNING! Beware of injury.
Keep a sufficient distance from objects or other vehicles. Once it is
retracted, it should be at least 40 cm away from other objects and
vehicles on all sides.
➤ Click the hand crank into the holder in the awning (fig. 1, page 2).
➤ Turn the hand crank until the awning is extended by about 1.5 metres (fig. 2,
page 2).
➤ Push the right strut in the front cover together so that you can move it freely
(fig. 4, page 3).
➤ Turn the right strut to the side (fig. 4, page 3).
➤ Fold the right strut down and set it on the ground (fig. 5, page 4).
➤ Adjust the strut to the required height (fig. 6, page 4).
➤ Fold the lever for the strut up to secure the struts (fig. 7, page 5).
➤ Extend the other strut in the same way.
➤ Turn the hand crank until the awning is extended to the required position.
Position the struts vertically and back under the front panel every 30 cm so that
the awning stays secured at all times.
➤ Turn the hand crank approx. a quarter of the way back to tighten the fabric.
A
NOTICE! Beware of damage.
The fabric of the awning should not hang down at the edges, and must
remain taut at all times. If the fabric hangs down, it could rub against the
arms and become damaged.
The fabric used for long awnings should not sag in the middle.
➤ Remove the hand crank from the holder on the awning.
16
PW1750
EN