Dometic PERFECTWALL PW1750 Notice D'utilisation page 17

PW1750
Extending the awning using a 12 V motor
!
WARNING! Beware of injury.
Keep a sufficient distance from objects or other vehicles. Once it is
retracted, it should be at least 40 cm away from other objects and
vehicles on all sides.
➤ Press the switch for the 12 V motor until the awning is extended by about
1.5 metres (fig. 3, page 3).
➤ Push the right strut in the front cover together so that you can move it freely
(fig. 4, page 3).
➤ Turn the right strut to the side (fig. 4, page 3).
➤ Fold the right strut down and set it on the ground (fig. 5, page 4).
➤ Adjust the strut to the required height (fig. 6, page 4).
➤ Fold the lever for the strut up to secure the struts (fig. 7, page 5).
➤ Extend the other strut in the same way.
➤ Press the switch for the 12 V motor until the awning has extended to the required
position. Position the struts vertically and back under the front panel every 30 cm
so that the awning stays secured at all times.
➤ Press the switch for the 12 V motor until the awning has retracted far enough to
tauten the fabric.
A
NOTICE! Beware of damage.
The fabric of the awning should not hang down at the edges, and must
remain taut at all times. If the fabric hangs down, it could rub against the
arms and become damaged.
The fabric used for long awnings should not sag in the middle.
EN
Operating the awning
17