Dometic PERFECTWALL PW1750 Notice D'utilisation page 20

Operating the awning
Retracting the awning using a 12 V motor
➤ Press the switch for the 12 V motor until the awning is only extended by about
1.5 metres. Position the struts vertically and back under the front panel every
30 cm so that the awning stays secured at all times.
➤ Fold the lever of the right strut down to loosen the struts.
➤ Slide the struts together completely.
➤ Fold the right strut up.
➤ Turn the right strut into the front panel.
➤ Slide the bottom part of the right strut into the latch of the front panel.
➤ Retract the other strut in the same way.
➤ Press the switch for the 12 V motor until the awning has retracted completely.
➤ Double-check that the awning is fully retracted before starting your journey. The
front panel should be right up against the housing.
A
NOTICE! Beware of damage.
If the awning is retracted when wet, extend it again and let the fabric dry
out at the next opportunity. If the wet fabric stays rolled up for a long
time, mildew will form and the fabric can fade.
7.4 Unrolling the blind
➤ Open the lock in the middle of the front panel (fig. c, page 7).
➤ Push the brackets on the right and left into the rails of the roller blind (fig. d,
page 7).
➤ Guide the tensioning belts or cords through the loops of the brackets (fig. d,
page 7).
➤ Pull the roller blind down evenly with both hands at the rails (fig. e, page 7). The
maximum extension height is 1.2 m.
➤ Secure the brackets on the right and left using the struts (fig. f, page 8).
or
➤ Secure the cords with pegs (fig. g, page 8).
20
PW1750
EN