Publicité
Les langues disponibles
Les langues disponibles
GAS WALL OVEN INSTALLATION INSTRUCTIONS
Installation Instructions for installing a 1½ cavity
oven into an existing 2 cavity opening with dimen-
sions 42-1/8" height by 22 ½" Width.
42
(107 cm)
Wood
runner
Height
adjuster
•
If width opening is too wide to secure unit to
cabinet with mounting screws, add plywood
•
If height opening is at 42-1/8", lower height
adjuster 1" (see section 4) and secure two 2" X
4" X 22" wood runners on each side at bottom
of opening (see Figure 4).
•
The decorative lower trim (not shown) can be
installed to hide the gap under the unit. It should
overlap by ¼" the front of the cabinet at bottom
of cutout (see step 2 of section 5).
1
/
22
"
2
/
"
1
8
(57.2 cm)
Hole for
Cord
Plywood
Remove and lay aside the lower vent decorative
trim that is taped to the side or to the top of the
oven. The decorative trim will be fastened to the
lower front of the oven after it has been installed
in the cabinet.
There is a 1 ½" height adjustment on models
with extension panel (see Figure 5). With this
adjustment and a ½" trim overhang, a unit can be
installed in existing openings 37 ½" to 39" high.
4
Adjustment
Holes
Extension
Panel Mounting
Screws
Publicité
