Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Problem
Engine Will Not Start
Engine Will Not Idle
Engine Will Not Accelerate
Engine Lacks Power or Stalls When
Cutting
C tting
Cutting Head Will Not Advance Line Cutting head out of line
If further assistance is required, contact your local Authorized Toro Service Dealer.
EN–17
Cause
Ignition switch is "OFF"
Empty fuel tank
Primer bulb wasn't pushed enough
Engine flooded
Carburetor misadjusted
Carburetor misadjusted
Throttle wire has come loose
Dirty air filter
No oil in fuel
Inner reel bound up
Cutting head dirty
Indexing teeth worn or burred
Line welded
Line twisted when refilled
Not enough line is exposed
Action
Turn switch to "ON"
Fill fuel tank
Press primer bulb fully and slowly
5-7 times
Use starting procedure WITHOUT
USING CHOKE
Adjust carburetor
Adjust carburetor
Tighten throttle wire
Clean or replace air filter
Add oil to fuel
Refill with new cutting line
Replace inner reel
Clean reel and spool
Replace reel and spool
Disassemble, remove the welded
section and rewind the line
Disassemble and rewind reel
Push the Bump Knob and pull out 4
in (102 mm) of line until the line is
outside of the cutting head
Publicité
