Publicité
Les langues disponibles
Les langues disponibles
2.
Dress properly. Do not operate this trimmer
when barefoot or wearing open sandals. Always
wear sturdy, rubber-soled footwear. The use of
gloves, ear/hearing protection and long pants are
recommended.
3.
Do not wear loose fitting clothing or articles
such as scarves, strings, chains, ties, etc. because
they could get drawn into the air intake. Also
make sure long hair does not get drawn into the
air intake.
4.
Keep hands, face, and feet away from all moving
parts. Do not attempt to touch or stop the string
when it is rotating.
5.
Do not touch the muffler or cylinder. These parts
get extremely hot from operation and remain hot
for a short time after the equipment is turned off.
6.
Always hold the trimmer with both hands when
operating. Keep a firm grip on both the front and
rear handles or grips.
7.
Operate this trimmer only in a well-ventilated
area — outdoors. Carbon monoxide exhaust
fumes can be lethal in a confined area.
8.
If the unit strikes or becomes entangled with a
foreign object, stop the engine immediately and
check for damage. Repair any damage before
further operation is attempted. Do not operate
the trimmer with loose or damaged parts.
9.
Use the right tool. Do not use this trimmer for
any job except that for which it is intended.
10. Do not force the tool at a rate faster than the rate
at which it is able to cut effectively.
11. Do not overreach. Keep proper footing and
balance at all times.
12. Do not operate the engine faster than the speed
necessary to cut, trim or edge. Do not run the
engine at high speed when not cutting.
13. The string guard must be in place at all times
while operating as a trimmer.
EN–3
14. Do not extend the trimming line beyond the
length specified in this manual.
15. Always stop the engine when cutting is delayed
or when walking from one cutting location to
another.
16. Use only genuine replacement parts when
servicing this trimmer. These parts are available
from your authorized dealer. The use of
non-standard parts, or other accessories or
attachments not designed for this trimmer, could
result in serious injury to the user or damage to
the trimmer and void your warranty.
Safety Warnings For The
Brush Blade During Use
1.
Read the safety instructions starting on page 2.
2.
Always use the shoulder harness when using the
brush blade accessory.
3.
Keep the J-handle between the operator and
cutting head at all times.
4.
Do not under any conditions cut with the blade
located over 30 inches (76.2 cm) or more above
the ground level.
5.
Scything should be done with extreme care and
caution.
6.
For operation with the standard 4-tooth blade, do
not cut anything thicker than 1/2 inch or a
violent kickback could occur.
7.
Do not attempt to touch or stop the blade when it
is rotating.
8.
Do not run the unit at high speed when not
cutting.
9.
If you strike or become entangled with a foreign
object, stop the engine immediately and check
for damage. Have any damage repaired before
further operation is attempted. Do not operate
unit with a bent, cracked or dull blade.
10. Keep the unit clean of vegetation and other
materials. They may become lodged between the
blade and guard.
Publicité
