Cole-Parmer essentials MP-400 Serie Manuel D'instructions page 5

LCD Screen: This display shows programming
information, menu options, stored results, the
current time and current temperature reading.
Keypad: This membrane keypad controls the
MP-400 via the following buttons:-
Upper and lower menu/option keys:
Selects the option displayed next to the key.
I key: During a melt, used to store up to
7 temperature readings for capillary 1. In the
preset method menu it selects the preset method
indicated on the screen above.
II key: During a melt, used to store up to
7 temperature readings for capillary 2. In the
preset method menu it selects the preset method
indicated on the screen above.
III key: During a melt, used to store up
to 7 temperature readings for capillary 3. In the
preset method menu, selects the preset method
indicated on the screen above.
Enter key: Selects the menu option
displayed above the key or exits/confirms the
current menu/action.
5.2 Main Screen
When the instrument is first switched on the
display will firstly show:
*** Cole Parmer MP-400 ***
MELTING POINT APPARATUS
After a short pause, the display will show the
main menu screen and three menu options.
Note: - All menu screens display the time
and current block temperature
The three menu screen options are:
REPEAT MEASUREMENT
- Perform a new melt using the parameters used
during the previous melt
NEW MEASUREMENT
- Perform a new melt
VIEW LAST RESULTS
- View the results from the last melt performed
Note:- Regardless of whether the electrical
supply is maintained, previously recorded
results are stored until a new measurement
is performed.
09:00
REPEAT MEASUREMENT
5.3 New Measurement Set-Up
1. Press the upper menu key next to the "NEW
MEASUREMENT" main menu option. The
display will change to:
09:00
PRESET PROGRAMME?
EXIT
Use the upper menu key next to the "YES"
option to select one of the MP-400's three
programmable preset methods and proceed to
50.0°C
NEW MEASUREMENT
VIEW LAST RESULTS
50.0°C
YES
NO
3