Garland GAS 339 E Manuel D'instructions page 33

- Press, repair or replace everything you need before
using the machine
6.3.2. FIXING CABLE EXTENSION
Only use cable extensions that are homologated for
outdoor use.
The cable section must be at least 1.5mm and the
cable extension should never be longer than 25m and
must be completely unrolled before starting to work.
Fix the cable by inserting it on the hook provided to
this effect at the back of the machine.
Ensure that the cable and the plug are in a perfect
state and that they comply with the machines
prerequisites.
Place the cable elongator in such a way that it does
not get tangled with branches and other cutting edges
and also ensure it is not dangling across the working
area. The cable elongator must always be behind the
machine and the end user.
6.3.3. START AND STOPPAGE
Start up of the machine:
Press the switch (¨ON¨).
Stopping the machine:
Release the switch (¨OFF¨).
6.3.4. CHECKING POINTS AFTER START UP
It is important to ensure that there are no loose parts
and to check the temperature of the machine. If you
detect anything strange, stop immediately and check
carefully. In case of any anomaly or problem take the
machine to your nearest service agent for repair.
Never carry on working if the machine does not seem
to work properly.
7. MACHINE USAGE
Use this machine only for jobs for which it has
been designed. The use of this machine for any other
jobs is dangerous and can cause dangers to the users
and/or to the machine.
Work only with good light. Do not use this machine at
night, with fog or with reduced visibility that does not
allow you to clearly see the working area.
Limit the usage of the machine to 10 minute stints
and rest for a further 10 to 20 minutes in between
sessions.
Avoid using the machine when the ground is wet or
humid. Be especially careful when using the machine
after it has rained as the ground will be slippery and
you could fall.
If you lose your balance or fall, let go of the handle
switch immediately.
33/120
English