MO-EL 891 Emploi Et Entretien page 11

Fix the support (Fig.1) to the wall or ceiling using at least 2 dowels.
The heater can be tilted on its support at screw A (Fig.6), and the
modules can be oriented at joints B (Fig.8-10). After adjustment,
tighten all screws.
- 891:
Follow the installation instructions on page 38 in the order 2-3-4-5-6.
- 892P:
Follow the installation instructions on pages 38-39 in the order 2-3-4-
10-5-6.
- 892L:
Follow the installation instructions on pages 38-39 in the order 7-8-9-
4-5-6.
- 893P:
Follow the installation instructions on pages 38-39 in the order 2-3-4-
10-5-6. Repeat operation 10 on the two sides.
- 893L:
Follow the installation instructions on pages 38-39 in the order 7-8-9-
4-5-6.
Repeat operation 9 on the two sides.
Make the electrical connections in the junction box as shown in
fig.11.
Fix the junction box to the wall support.
Connect the power cable as shown in fig.13 and close the box.
It is possible to change the heat concentration by moving the lamp
before installation:
Standard
configuration
Concentrated
heat beam.
Recommended
installation height
4-7 m.
Loosen the screws that support the lamp, move it to the desired
position, and tighten the screws again.
11
Offset
configuration
Diffused heat
beam
Recommended
installation height
3-5 m.