MO-EL 891 Emploi Et Entretien page 10

power supply by a H05RN-F cable, gotten properly into dimension in
respect to its own length and the kind of the connection.
An overvoltage category III Combined Circuit breaker and
Residual Current Device (RCD) with rated earth leakage
operation not exceeding 30mA must be fitted upstream on the
supply line. The circuit breaker must have a contact opening
distance of at least 3 mm.
The appliance have a protection degree IP55, so they can be placed
outside.
Keep the indicated distances between the heater and the wall/
•
ceiling.
Install the heater in such a way that the lamps stay horizontally.
•
A safety distance of not less than 2 m should always be left in front
•
and to the side of the heater.
The appliance must not be located neither directly below, nor in
•
front of a socket-outlet.
Do not use the heater directly near a bathtub, a shower, a swimming
•
pool.
Ensure that the power cable cannot come into contact with the
•
reflector of the appliance and does not intrude into the area of light
flux.
Ensure that there is no possibility of inflammable material,
•
combustible material or curtains coming into contact with the
Heater, or lie near the heater.
All irradiation heaters are designed to achieve and maintain a certain
thermal comfort to the people who need it both outside and inside. It
is therefore very important to carefully study the area where people
stay and consequently direct the radiation towards them.
All accessories are protected by a film which must be removed
before assembly.
Wall mounting using the braket (provided)
Make sure that the wall where you plan to mount the appliance
is solid, and free of electrical cables or water pipes inside.
This heater is intended for permanent installation. Be sure that
the heater is not facing the ceiling or inflammable substances
10
.