EINHELL HYPRESSO 18 Mode D'emploi page 16

10. Troubleshooting
Problem
The equipment
does not work.
The motor starts but
there is no pressure
build-up.
The operating
pressure is irregular.
Anl_Hypresso_18_24_Li_SPK7_USA.indb 16 Anl_Hypresso_18_24_Li_SPK7_USA.indb 16
EN
Cause
- No electrical voltage at the
equipment.
- The pump is frozen.
- The water intake fi lter is clogged.
- Air intake in the water inlet.
- The discharge nozzle is too large.
- The water cock is closed.
- Air intake in the water inlet.
- 16 -
Solution
- The battery is not charged.
- The battery is not correctly
connected.
- Check and thaw if necessary.
- Clean the water intake fi lter.
(see 7.2)
- Check the supply hose and hose
connectors and replace them if
necessary.
- Check and replace if necessary.
- Turn open the water cock.
- Check the supply hose and hose
connectors and replace them if
necessary.
15.11.2023 09:46:55 15.11.2023 09:46:55