Publicité
Les langues disponibles
Les langues disponibles
SET UP INSTRUCTIONS
Auto Off Function
When powering the scale via the AC adapter, the display can be set to power off after a period of inactivity.
The Auto Off default setting is "disabled". Follow this procedure to enable or disable the Auto Off function.
Note: When powering the scale via batteries, the Auto Off function is automatically enabled.
Enable / Disable Auto Off
1. While the scale is turned off, press and hold the ENTER button then press and release the button. Hold the
ENTER button until "AOF=d" or "AOF=E" appears on the display, then release. Press the ENTER button
again to change the setting.
AOF=d
Disables the Auto Off function
AOF=E
Enables the Auto Off function
2. Press CLEAR to save your selection and exit the Options mode.
3. The scale will restart. The display will show "UEr", followed by a version number, and then dashes. When
the display shows "0.0" the scale is ready to use.
Setting Auto Off Time
When powering the scale via batteries or if Auto Off is Enabled for the AC adapter, the period of inactivity before
the scale powers off can be set to a specific amount of time. The default setting for Auto Off time is 2 minutes.
Follow this procedure to set the number of minutes of inactivity before power off.
1. While the scale is turned off, press and hold the ENTER button then press and release the
button. Hold the ENTER button until "AOF=d" or "AOF=E" appears on the display, then release. Use the ▲
or ▼ buttons to advance the display screen until "AFt" appears. Press the ENTER button to change the
Auto Off time.
AFt = 1
Scale will power off after 1 minute of inactivity
AFt = 2
Scale will power off after 2 minutes of inactivity
AFt = 3
Scale will power off after 3 minutes of inactivity
2. Choose the setting you prefer and press CLEAR to save your selection and exit the Options mode.
3. The scale will restart. The display will show "UEr", followed by a version number, and then dashes. When
the display shows "0.0" the scale is ready to use.
Setting Sound Options
The display can be set to stay silent or beep while operating the scale. The default setting for Sound is
"enabled". Follow this procedure to enable or disable sound.
1. While the scale is turned off, press and hold the ENTER button then press and release the
button. Hold the ENTER button until "AOF=d" or "AOF=E" appears on the display, then release. Use the ▲
or ▼ buttons to advance the display screen until "Snd" appears. Press the ENTER button to change the
setting.
Snd = E
Enables sound so the scale beeps when keys are pressed.
Snd = d
Disables sound so the scale stays silent when keys are pressed.
2. Choose the setting you prefer and press CLEAR to save your selection and exit the options mode.
3. The scale will restart. The display will show "UEr", followed by a version number, and then dashes. When
the display shows "0.0" the scale is ready to use.
9
Back to Home Page
Publicité
