Anslut 023265 Traduction Des Instructions D'origine page 27

Example: Wednesday 9.30, set temperature 25°C.
1. Hours
2. Minutes
3. Day
4. Setting the temperature
FIG. 9
Weekly programming
(remote control)
NOTE:
The clock must be set before programming.
1. Press to start the product.
2. Press "P" to go to weekly programming
mode (status light "P" on).
3. Press the DAY to enter day of the week for
programmed switching on (d1, d2 ... d7).
4. Press EDIT to select the required period
(P1, P2 .. .P6).
5. Press TIME/ON to set starting time (00,
01, 02 ... 24).
– Minutes cannot be set.
6. Press TIME/OFF to set switching off time
(00, 01, 02 ... 24).
– Minutes cannot be set. TIME/OFF
cannot have a smaller value than
TIME/ON.
7. Press + or – to set the the temperature for
the period.
8. Press OK to confirm.
9. Repeat steps 4 to 8 to set an additional
period during the same day.
– Up to 6 periods can be programmed
for each day.
10. Repeat steps 2 to 8 for settings for other
days.
11. Press "P" to activate the weekly
programme (status light P on) or to
deactivate it (P off).
12. When the programming is finished the
settings can be checked by pressing DAY/
EDIT TIME/ON and TIME/OFF.
NOTE:
• If the start time is the same as the
switching off time the product goes on
standby.
• If no temperature setting is made the
standard setting of 23°C will be used. If
the room temperature is higher than
23°C the product will not start.
• The weekly programming is deleted if
the product is switched off.
Example: Monday, first period 07:00 to 13:00.
1. Press P
2. Day
3. EDIT Time/On
4. Time/Off OK
FIG. 10
Setting for detection of
temperature drop (remote control)
1. Press to start the product and allow it
to run in heating mode until it stabilises.
2. Press to activate detection of temperature
drop mode (status light
3. Press + or – to set the temperature for
detection of temperature drop.
4. Press to deactivate detection of temp-
erature drop mode (status light
5. The product returns to the previous mode.
FIG. 11
• If the room temperature drops by the
specified value between 5 and 10°C in
less than 10 minutes the product goes on
standby. Press
again.
• If detection of temperature drop and
weekly programme does are active at the
same time the product will not start if its
is switched off by the weekly programme.
If the product is started by the weekly
programme it will continue to run at the
set temperature even if a temperature
drop is detected.
on).
off).
to start the product
EN
27