Anslut 023265 Traduction Des Instructions D'origine page 25

• Do not cover the product, this can result
in overheating.
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Safety class II.
WARNING! Do not
cover the heater – risk
of overheating.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Rated voltage
Output
Cord length
Protection rating
Size W16.4 x H28.5 x D26.5 cm
Weight
INSTALLATION
NOTE:
The product is intended for installation on
a wall. Do not attempt to use the product
freestanding.
Install the product in accordance with the
following instructions.
1. Choose a place to install the product.
2. Drill two holes with a diameter of 8 mm in
the wall. Make sure the distance between
the holes is 187 mm.
FIG. 1
3. Put plugs in the holes and screw in the
screws. Do not screw in the screws all the
way, the screw heads should stick out
230 V ~ 50 Hz
2000/1000 W
1.45 m
IP22
1.8 kg
about 10 mm.
4. Hang up the product on the wall. Align
the two holes on the back to the screws,
put the product on the screws and press it
down to lock in place.
USE
NOTE:
If a power failure occurs, the product will
default to frost protection mode.
CONTROL PANEL
Switching on/off
Press the power switch to switch on (I) and
switch off (O) the product.
1. Power switch
2. Weekly programming
3. Timer (switching on/off)
4. Heating half power (1000 W)
5. Heating full power (2000 W)
6. Temperature setting
7. Mode to detect temperature drop
8. Mode selector
FIG. 2
1. Normal operation.
2. Temperature setting and confirmation of ErP.
3. Weekly programming and mode to detect
temperature drop.
FIG. 3
NORMAL OPERATION
Fan and heating (control panel)
Press F to select one of the following modes.
1. The product goes in standby mode (fan
stops after 30 seconds in standby mode).
2. Fan without heat
3. Heating half power
4. Heating full power
FIG. 4
The standard set temperature is 23°C when
the status light °C is off.
EN
25