Anslut 023265 Traduction Des Instructions D'origine page 26

EN
Fan and heat (remote control)
• Press to start the product.
• Press to select one of the following
modes.
1. Fan without heat
2. Heating half power
3. Heating full power
4. The product goes in standby mode. The fan
stops after 30 seconds in standby mode.
FIG. 5
Press again to switch off the product.
Temperature setting
(remote control)
1. Press to start the product.
2. Press + or - to set the required
temperature from 10 to 49°C
(status light °C on).
– The figure shows the display if the
room temperature is 15°C and the
set temperature is 25°C.
FIG. 6
3. Press to delete the temperature setting
(status light °C off) and select heating at
half power (*) or full power (**).
– If the temperature is 4°C, or more,
below the set temperature the
product will work at full power.
– If the room temperature is between
0 and 2°C below the set temperature
the product will work at half power.
– The product switches off when the
room temperature is higher than the
set temperature. The fan continues
to run for 30 seconds to cool the
components in the product. The fan
then stops and the product goes in
standby mode. The product starts
again when the room temperature
drops more than 2°C below the set
temperature.
26
Switching on/off (control panel
and remote control)
Delayed start
Press to set the required delay from 1 to
12 hours (status light
– The counter on the display counts
down the hours. The product starts
automatically after the set delay. The
set standard temperature is 23°C.
– If no temperature setting or weekly
programming is made the product
will run continuously for 12 hours
and then go on standby.
Example of adjusting delayed start of eight hours.
FIG. 7
Stop delay
Press to set the required stop delay from
1 to 12 hours (status light
delay the product switches off automatically.
The standard set temperature is 23°C.
Example of adjusting delayed start of 8 hours.
A. 5 seconds
FIG. 8
Weekly programming and mode
for detection of temperature drop
Setting the clock (remote control)
1. Press to start the product.
2. Press SET to show hours.
3. Press + or – to set the hours (00 to 23).
4. Press SET again to show minutes.
5. Press + or – to set the minutes (00 to 59).
6. Press SET again to show days.
7. Press + or – to set the days.
– d1 = Monday, d2 = Tuesday etc.
8. Press OK to confirm.
9. Press SET again to show time and set
temperature. The clock must be reset if
there is a power failure.
on).
on). After the set