EUROM Barcelona Manuel D'utilisation page 31

 Unscrew the broken lamp and replace it by
a 25W E14 SES clear candle lamp. Do not
screw in the lamp too tight!
 Refit the panel and tighten the screws.
Safeguards
The Barcelona atmospheric fireplace is equipped with an overheating safeguard.
The overheating safeguard switches the heater off if it overheats internally. This
may occur if the heater cannot give off enough heat or if it cannot draw in enough
fresh air. As mentioned above, this is generally caused by (partially) covering the
heater, obstructing the air intake and/or outlet grills or installing the heater too
close to a wall or something similar. If this happens, turn the fireplace off by
switching the main switch to O and remove the plug from the socket. Leave the
fireplace to cool down for at least 15 minutes and remove the cause of overheating.
You can then switch the fireplace back on. If the device overheats again or you
cannot ascertain the reason for this, take the fireplace to your service point to be
checked/repaired.
Important! For safety reasons the fire will not automatically restart after
overheating. Check whether conditions are safe before switching it on! So never
switch on the heater by means of a timer and never connect it to a power supply
that regularly switches on and off.
Cleaning and maintenance
Always remove the plug from the socket and let the fireplace cool down before
cleaning or touching. The Barcelona atmospheric fireplace does not need much
maintenance. Always keep the in- and outlet openings clean and dust-free. Use a
soft cloth or a soft brush to clean the outside of the metal case. The glass plate can
also be cleaned with a soft cloth. Do not use abrasive cleaning fluids or special
glass cleaners! Apart from the bulbs, the fireplace contains no parts which need to
be replaced by the user. If the device malfunctions, immediately remove the plug
from the socket and take to a service point. Do not carry out repairs yourself and
31