EUROM Barcelona Manuel D'utilisation page 30

• Completely unwind the electrical cable and insert the plug into a suitable 220-
240V earthed socket. To prevent overloading, check that no other equipment is
connected to the same group.
Operating
 Check that the details on the data plate correspond to those of the electrical
supply which you wish to use for the fireplace. Do not use the same connection
for any other equipment.
 The three control switches and
the thermostat knob are located
behind the metal panel on the
front of the heater. Pull out the
panel and you will find three
control switches. By pressing
the bottom switches you will
make the following happen:
Switch 1:
Switches 1+2:
Switches 1+2+3:
 Check whether switch 1 is set to OFF (O depressed)
 Connect the plug to an earthed power outlet.
 Turn the thermostat dial to maximum (clockwise as far as possible).
 Press switch 1 and, depending on what you want, switches 2 and 3 to start
using the heater.
 Once the desired temperature is reached, turn the thermostat dial back slowly
until you hear a click. The temperature is now set. The heater will automatically
switch on and off to maintain the set temperature. To set a higher or lower
temperature, turn the thermostat dial either clockwise or anticlockwise.
 Switch off the heater by resetting all switches to the OFF position. Remove the
plug from the power outlet; do this whenever the heater is not in use!
Replacing a bulb
Warnings:
 Always unplug the fireplace before replacing a bulb!
 The bulbs get hot during use; allow plenty of time for them to cool down before
touching them!
 The two lamps are located behind the small panel at the rear of the fire. To get
to the lamps you must unscrew two screws that keep the panel in place. Slide
the panel downwards and remove it (see figure).
switch on the power supply to the heater and the flame
effect (without heating) (O depressed is OFF - I depressed
is ON).
switch on 1000 Watt heating, with flame effect
switch on 2000 Watt heating, with flame effect
30