Publicité
ASSEMBLY AND HOOK-UP INFORMATION
SINGLE BURNER MODEL
1. Be sure the heater is facing away from tank. Insert the regulator connector into the tank valve outlet fitting and turn left
(counter clock-wise) until fully tightened. Do not overtighten.
2. Loosen the wingnut located on the venturi tube. Place the heater support around venturi and rest the bottom of the heater
support on the propane cylinder. Tighten the previously loosened wingnut to secure the heater support onto venturi tube.
3. Operate only on a stable, level surface.
4. Open propane tank valve slowly.
5. Check all fittings for leaks. Apply a 50/50 mixture of liquid soap and water to all joints. Bubbles forming indicate a leaking
connection. Correct all leaks before proceeding.
WARNING: NEVER TOUCH HEATER WHILE IN OPERATION TO AVOID INJURY. MOVE HEATER BY GRASPING THE
PROPANE CYLINDER CAREFULLY.
6. The heater should be inspected before each use and at least annually by a qualified service person.
7. The hose assembly shall be visually inspected prior to use of heater. If it is evident there is excessive abrasion or wear, or
the hose is cut, it must be replaced prior to the heater being put into operation. Replacement hose assembly shall be hose
assembly as listed in the parts list.
8. Minimum inlet gas pressure is 20 psi.
9. Maximum inlet gas pressure is 120 psi (equivalent to an ambient temperature of 75°F (24°C)).
WARNING: Never leave the heater unattended while operating.
Disconnect the heater from its power source when not in use.
-6-
Publicité
