Publicité
ASSEMBLY AND HOOK-UP INFORMATION
3. Align the bolt holes in the tank collar bracket with the bolt holes located in the center plate of the manifold. Using the
previously removed screws, secure the center plate manifold to the collar bracket. NOTE: The heater MUST be facing away
from the tank once it has been attached to the collar bracket. Make sure that tip switch bracket is between the tank collar
bracket and the manifold center plate.
4. Make sure heater regulator is in the "OFF" position. Insert regulator's connector into tank's valve and turn left (counter clock-
wise) with hand as much as possible. Do not overtighten.
WARNING: Never leave the heater unattended while operating.
Disconnect the heater from its power source when not in use.
-5-
Publicité
