Publicité
LIGHTING INSTRUCTIONS
Before attempting to light the heater, check all fittings and connections with a soap solution. NEVER USE A MATCH TO CHECK
FOR LEAKS. Should a gas leak occur, do not attempt to repair or use heater. Return the heater to your dealer or the address given
on back page.
Fuel – This heater must be used only with a vapor withdrawal LP gas bulk cylinder. THE BULK TANK MUST BE EQUIPPED WITH
A STANDARD POL VALVE.
WARNING: USE HD.5 PROPANE GAS ONLY. DO NOT USE ANY OTHER TYPE FUEL. SEE YOUR PROPANE DEALER IF
YOU HAVE ANY QUESTIONS REGARDING FUEL.
1. Turn the heater's "Hi-Med-Lo-Off" regulator knob to "Hi" (counterclockwise). Stand to the side of the unit while lighting. Do
not stand or have any part of the body over or in front of the heater while lighting.
2. Place a lit match inside the hole located on the left-hand side of the rear reflector.
3. Depress and hold the valve button located on the safety shutoff valve. After the heater is lit, continue to hold the valve button
in for 30 seconds, then release the button slowly. CAUTION: DO NOT PUSH IN VALVE BUTTON BEFORE INSERTING THE
LIT MATCH. NEVER STAND IN FRONT OF THE HEATER WHILE LIGHTING.
4. If burner does not light within 30 seconds, turn the heater's regulator knob to "Off" (clockwise) and allow at least five minutes
for gas to dissipate before attempting to relight.
5. NOTE: Should the orifice become clogged as indicated by low volume of gas when operating on "Hi" with a full cylinder, or
should the heater fail to operate properly for any reason, return the heater to the dealer or the address given in this manual
for repair or replacement. DO NOT ATTEMPT TO REPAIR OR TAMPER WITH HEATER.
6. Adjust heat output by turning knob to desired position.
DO NOT USE THIS HEATER FOR COOKING.
WARNING: Never leave the heater unattended while operating.
Disconnect the heater from its power source when not in use.
OPERATION
-10-
Publicité
