Publicité
SHUTDOWN AND STORAGE INSTRUCTIONS
A. The bulk propane tank "ON-OFF" valve should ALWAYS be completely turned "OFF" when the heater is not in use.
B. When shutting off the heater, turn the regulator knob on the heater to "OFF" (clockwise).
C. CAUTION: After turning unit off, heater will remain extremely hot. Allow at least 15 minutes for cooling before handling and
storing. Detach heater from bulk tank before handling and storage. REMEMBER – POL fitting is a left-hand thread.
D. HEATER STORAGE: Indoor storage of the heater is permissible only if the cylinder is disconnected and removed from the
heater. Cylinders must be stored outdoors out of the reach of children and must not be stored in a building, garage or
any other enclosed area. Store cylinders only in accordance with the Standard for the Storage and Handling of Liquefied
Petroleum Gases ANSI/NFPA 58 and CSA B149.1, Natural Gas and Petroleum Installation Code.
E. See the "Parts List" section of this manual.
A. Remove thermocouple retaining bracket screw from back of burner assembly. Remove bracket.
B. Note position of thermocouple in retaining tabs on the back of the Burner assembly. Remove the thermocouple.
C. Remove wing bolt and fiber washer that attached the safety shut-off to the burner Assembly.
D. Slide the safety shut-off from burner assembly.
E. Remove burner orifice from the safety shut-off.
F.
Clean burner orifice with compressed air (80 psi max).
G. Direct compressed are through the burner venturi tube toward the burner plenum so that dust collected on the grid screen
will be blown outward. Keep face away from the grid screen.
H. Reassemble heater in reverse order of disassembly.
WARNING: Never leave the heater unattended while operating.
Disconnect the heater from its power source when not in use.
OPERATION
MAINTENANCE
-11-
Publicité
