Cuda surgical Elite 1000 Mode D'emploi page 5

•
This device meets CISPR 11 Class A limits and is suitable for use in a hospital and industrial
environments. If it is used in a residential environment (for which CISPR 11 class B is
normally required) this equipment might not offer adequate protection to radio-frequency
communication services. The user might need to take mitigation measures, such as
relocating or re-orienting the equipment.
•
Performance of this device may be affected in proximity of another device and/or equipment
capable of producing high levels of RF emissions. The device should be used no closer than
12 inches (30 cm) to any part of RF equipment including cables. In the event performance of
this device is affected due to high levels of RF emissions, relocation of the suspected device
and/or equipment producing high levels of RF emissions, or the headlight system may
reduce or eliminate the problem.
2.2 Cautions
•
Before each procedure, carefully check the illuminator for damage. DO NOT use a damaged
illuminator.
•
The user should verify the light guide end tip and the active illumination port are of the same
type before insertion. DO NOT attempt to force an end tip into an incorrect port.
•
All servicing and repair must be performed by the manufacturer or qualified service
technicians.
•
Ensure that the air vents located on the illuminator are not obstructed to allow the device to
receive the necessary cooling to prevent an overheating.
•
Any serious incident that has occurred in relation to the device should be reported to the
manufacturer and the competent authority of the Member State in which the user and/or
patient is established.
®
LIT-217 CUDA Surgical
Rev.F
Page 5 of 98
(English)