Publicité
Les langues disponibles
Les langues disponibles
Programme operations
When a programme is running the relevant
indicator light will remain on and the 3
"PROGRAMME STATUS" indicator lights
("WASH"
, "RINSE"
will light singularly and in sequence to
indicate the current phase.
If there is any break in the power supply
while the dishwasher is operating, a
special memory stores the selected
programme and, when the power is
restored, it continues where it left off.
Programme end
A 5 second alarm will sound (if not muted)
3 times at 30 second intervals and the
programme indicator light will flash to
indicate that the washing programme has
finished. The dishwasher will automatically
switch off.
Option buttons
"EXPRESS" button
This button provides an energy and time
saving of 25% on average (according to
the select cycle) reducing the wash water
temperature and the drying time during the
final rinse.
This programme is recommended for light
soil washes, and for slightly wet dishes that
are not fully dry, & improved drying results.
We advise you to leave the door of the
Dishwasher half-open at the end of the
cycle, to allow for a natural circulation of air
inside the dishwasher.
Salt empty indicator
This model is provided with an indicator
light on the control panel which will light up
when it is necessary to reload the salt
container.
The appearance of white stains on dishes
is generally a warning sign that the salt
container needs filling.
, and "DRY"
)
"RESET" button for
"SALT EMPTY" light
After filling the salt container, you should
press this button for a few seconds, until
the corresponding indicator light switches
off.
WARNING!
If you press the reset button without
filling the salt container, this will
interfere with the correct functioning
of the salt indicator light.
IMPORTANT
In order to guarantee the correct
functioning of the salt indicator
light, YOU MUST ALWAYS FULLY
REPLENISH THE SALT CONTAINER.
"DELAY START" button
The dishwasher start time can be set with
this button, delaying the start by 3, 6 or 9
hours.
Proceed as follows to set a delayed start:
Choose a programme by pressing the
"PROGRAMME SELECTION" button.
Press the "DELAY START" button (each
time the button is pressed the start
will be delayed by 3, 6 or 9 hours
respectively and the corresponding time
indicator light will illuminate).
To start the countdown, press the
"START" button (the set time indicator
light will start to flash).
If a 9 hour delay is set, countdown will be
displayed by the 6h indicator light after 3
hours and the 3h indicator light after 6
hours.
At the end of the last 3 hours (at the end
of countdown) the 3h indicator light will
stop flashing and remain on to indicate the
washing phase and the programme will
start automatically.
50
Publicité
