Publicité
Les langues disponibles
Les langues disponibles
ADDITIONAL SAFETY INSTRUCTIONS
Please read these safety instructions before use and
keep them in a safe place.
! - This symbol indicates the risk of injury or damage
to the device.
! Failure to follow the instructions in this manual may
result in injury.
! The cordless drill / screwdriver (hereinafter referred
to as the cordless drill) complies with the applicable
technical regulations and standards.
! Do not use the tool, accessories or charger for
purposes other than those for which they are
designed.
! If in doubt, before drilling holes or screwing into the
wall, use a metal detector to check that electrical
cables, gas or water pipes are not routed where you
want to drill.
Safety instructions for battery and charger.
Read the operating instructions carefully before using
the battery and charger for the first time.
! 1. Verify that the electric current that is in the el.
network, is identical to the values indicated on the
battery charger.
! 2. Do not allow moisture, rain or splashing water to
reach the battery charging location.
! 3. Do not charge the battery when the temperature
is below 10 ° C or above 40 ° C. Charging the battery
in extreme temperatures may shorten its life.
! 4. A damaged battery that can no longer be charged
must be treated as hazardous waste. Do not dispose
of the battery in normal household waste, fire or
water.
! 5. Use only batteries and chargers approved by the
manufacturer for use with married equipment.
! 6. Keep the charger clean, free of dust and dirt.
! 7. Always remove the battery before repairing tools.
! 8. Cover the battery contacts to prevent a short
circuit.
! 9. Avoid the risk of explosion!
! 10. Do not smoke while the battery is being charged
or stored. Damaged batteries can leak explosive
gas - hydrogen, which can ignite from open flames
or sparks.
! 11. In case of fire, try to extinguish the fire with earth
or sand.
! 12. The battery and charger become slightly hot
during charging.
! Chemical hazard.
Do not open the battery pack. Protect the battery
from impact. If the accumulator electrolyte leaks,
skin contact must be avoided. If electrolyte contact
with the skin still occurs, rinse the affected area
immediately with water. If electrolyte gets into your
eyes, see a doctor immediately.
- Use protective equipment against noise, dust and
vibration !!!
SAVE THESE SAFETY INSTRUCTIONS !!!
DESCRIPTION
This cordless drill / screwdriver is designed for drilling
holes in wood, metal, masonry and screwdriving.
Do not use the tool, accessories or charger for any
purpose other than that for which they are designed!
All other uses are expressly prohibited.
1. Torque setting
2. Soft handle
3. Direction of rotation switch
4. On/off switch
5. Accumulator
6. Charger
7. Switch 1st speed. stage – 2nd speed degree
8. Latch button
9. Quick-release chuck
10. LEDs
accessories
1x charger
1x bit
1x attachment
Pictograms
Pictograms on the product packaging:
a) Power supply
b) Idle speed
c) Chuck
USE AND OPERATION
ASIST tools are intended for home or hobby use only.
The manufacturer and importer do not recommend
using this tool in extreme conditions and under heavy
loads.
Any other additional requirements must be subject
to agreement between the manufacturer and the
customer.
Charging the battery cell
1. Pull the battery cell (5) out of the handle,
while pressing the side latch button (8).
2. Compare whether the listed mains voltage matches
on the type plate with the mains voltage which is k
available. Insert the mains plug of the charger (6)
into the socket.
3. Connect the charger plug to the charging socket
4. Charge for 3-5 hours
5. The battery may get a little warm during charging,
but this is normal.
If the battery cell was not charged
possible, please double check
• whether mains voltage is available in the socket
41
Publicité
