Operation; General; Changing The Setpoint Temperature - Hatco PW Série Manuel D'installation Et D'utilisation

English

General

Use the following procedures to operate the Plate Warmer.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
Startup
1. Move the Power I/O (on/off) switch to the I (on) position.
BURN HAZARD: Some exterior surfaces on the unit will
get hot. Use caution when touching these areas.
2. Allow 60 minutes to preheat the unit.
NOTE: The digital temperature controller is preset to a setpoint
temperature of 104°F (40°C) at the factory. Once the
setpoint temperature is changed, the new setpoint
temperature will remain in memory until it is changed
again. The minimum to maximum setpoint temperature
range is 104°F (40°C) to 122°F (50°C).
Shutdown
1. Move the Power I/O (on/off) switch to the O (off) position.
2. Unplug the power cord/turn off power at circuit breaker
and allow the unit to cool before performing any cleaning
or maintenance.

Changing the Setpoint Temperature

Use the following procedure to change the setpoint temperature.
1. Press the key one time.
• The icon will flash on the screen.
2. Press the key or
the setpoint temperature.
3. Wait 10 seconds to save the new setpoint temperature.
Form No. PWM-0721
CAUTION
key within 5 seconds to change
Set Key
Digital
Temperature
Control
Up Key
Down Key
Control Panel
7

OPERATION

Power I/O (on/off)
Switch
Controls
Power I/O Switch